Running the Project

To run your project on a ZC702 board:

1. FromProject Explorer, select thelab1/Releasedirectory and copy all files inside thesd_carddirectory to the root of an SD card.
2. Insert the SD card into the ZC702 and power on the board.
3. Connect to the board from a serial terminal in the SDx Terminal tab (or connect via Putty/Teraterm withBaud Rate: 115200,Data bits: 8,Stop bits: 1,Parity: None andFlow Control: None). Click theicon to open the settings.
   
4. Keep the default settings in the Connect to serial port window and clickOK.
5. After the board boots up, you can execute the application at the Linux prompt. Type/mnt/lab1.elf.